Getting Started PTB: Difference between revisions
No edit summary |
No edit summary |
||
| Line 38: | Line 38: | ||
</syntaxhighlight> | </syntaxhighlight> | ||
9. [[Media: | 9. [[Media:reset_ptb.jpg | Restart PTB]] | ||
The serial debug window should have something like the following output: | The serial debug window should have something like the following output: | ||
[[File:PTB-boot.png|400 px]] | [[File:PTB-boot.png|400 px]] | ||
Revision as of 08:00, 13 September 2019
Getting Started
1. Fetch changes from upstream repo
2. Checkout tag of your select release. See releases. This guide assumesPTB-v2.0.
<syntaxhighlight lang="bash"> $ git checkout PTB-v2.0 </syntaxhighlight>
3. Make sure repo is clean
4. Get pre-built bitstream.
<syntaxhighlight lang="bash"> $ make get_latest_bitstream TAG=PTB-v2.0 </syntaxhighlight>
5. Build embedded software
<syntaxhighlight lang="bash"> $ make sdk_gen_projects PRJ=PTB </syntaxhighlight>
6. (Optional) Open a new terminal window and start debugging stream. Shows messages from embedded system once programmed.
<syntaxhighlight lang="bash"> $ make serial </syntaxhighlight>
8. Generate bootloader and program flash
<syntaxhighlight lang="bash"> $ make gen_bootimage $ make program_flash </syntaxhighlight>
9. Restart PTB
The serial debug window should have something like the following output:
