Using IPbus
Main Page -> Control & Readout Software Documentation and Howto's -> Using IPbus
Use case
IPbus is a control protocol that uses UDP/IP to send values into the registers on the readout unit (RU). The software on the host computer uses the Hardware Access Library (uHAL) to send the commands to the RU.
Configuration files
There is a main connection file (pRU-connections.xml), this file contains the address and port of the RU, for information on the content of the connection file please see the pRU Ethernet Configurations document.
Following there is a Module registers file (module-address.xml), this file contains a table with all the registers present in the RU.
Finally, there are files for each register
- global_regs.xml
- trigger_manager.xml
- offload.xml
- alpide_control.xml
- alpide_data.xml
As of the writing of this page, these files can be found on the production_test repository in the ipbus branch under the BSP folder.
WARNING: To prevent undefined behavior the register files MUST match the firmware version!
Smart Dummy Hardware
To be able to read values from registers, a custom DummyHardwareUdp.exe can be built from this repository: IPbus Custom Repo NOTE: Remember to switch to the smartdummy branch.
This adds a file reader in the DummyHardware.cpp that reads a file in the directory of the executable, the file is called register-values.txt, an example file can be found here: Example file
How to Build on Ubuntu 20.04 LTS
REQUIRED PACKAGES
$ sudo apt update
$ sudo apt install git g++ make erlang python3 python-is-python3 libboost1.71-all-dev libpugixml-dev
BUILDING
In the directory where the repository have been downloaded:
$ make
$ sudo make install prefix=/home/user/ipbus-install
ADDING PATHS TO ENVIRORMENT
$ export LD_LIBRARY_PATH=/home/user/ipbus-install/lib:$LD_LIBRARY_PATH
$ export PYTHONPATH=/home/user/software-dev/ipbus-install/lib/python3.8/site-packages:$PYTHONPATH
RUNNING THE EMULATOR
Change directory to ipbus-install/bin/uhal/tests NOTE: Make sure the register-values.txt file is present in this folder.
./DummyHardwareUdp.exe -p 50001 -v 2 -V
Additonal information
For more information, please consult the IPbus wiki at: IPbus wiki