Running pDTPClient

Main Page -> Control & Readout Software Documentation and Howto's -> Running pDTPClient

Use case

The main task of this program is to get data from the proton Readout Unit (pRU) hardware to a host computer for storage or parsing.

The pDTPClient handles the proton Data Transfer Protocol (pDTP) using UDP. pDTP has three main modes; Request read (RQR), a single packet from 1 byte to 4080 bytes. Request stream (RQS), a single packet up to 65535 packets. And request full stream (RQFS). For more in-depth details about pDTP see: pDTP spesification

If the file writer is enabled the client will produce time and date stamped file that in a binary format.

Simplified diagram of offload chain

Optimal configuration

Due to the RUs ability to max out the 10Gbit link with small package sizes (high burst) and the Linux kernels inability to process large amounts of packages, and optimal configuration is advised.

There is also a consideration to be made with the size of the queue between the pDTPClient and the file writer/parser.

The config file

The config file exists to load the diffrent settings of the client in a easy manner.

#Config file for the settings to the pDTPClient
#IP adress to the PRU
IP = 192.168.100.200
#IP = 127.0.0.1
#PORT 30000 for data and 29070 for loopback
PORT = 30000
#Size of request stream 1 to 65535
SSIZE = 10
#Size of packet, 1 to 4080
PSIZE = 4080
#Start mode: RQT, RQR, RQS, RQFS, GS, ABRT
MODE = RQS
#Time to run client in seconds: 0 for disable.
RTIME = 0
#UDP recv timeout in microsecounds, 0 to disable
UDPTIMEO = 4
#Request a certain number of words, then stop the client, 0 to disable
NUMREQ = 0
#Set the verbosity for log messsages to console
VERB = 2
#Set the size of the SPSC queue
SPSCSIZE = 10000
#Poll PRU, yes = 1, no = 0
POLL = 1
#FileWriter Enable = 1, Disable = 0
ENABLEFILE = 1
#How to handle the buffer fill level, 0 = no RQS,RQFS, 1 = RQS, no RQFS or
#2 = RQS and RQFS.
SMODE = 0
#Set no wait flag
NOWAIT = 0
#Set maximize flag
MAXIMIZE = 0

Starting the client

The client can be run with the command:

./pDTPClient --config <location/config.conf>