Hardware Documentation and Howto's

Main Page -> Hardware Documentation and Howto's

Getting Started

• VCU118
• PTB

Documentation

pRU

• pRU Clock Network
• pRU Address Map
• DCS and Data Offload Ethernet Configurations
• pCT Data Transfer Protocol
• pRU Data Format
• FPGA and ALPIDE radiation calculations
• pRU Control Interface [Deprecated, only in use on PTB. Replaced with IPBus on VCU118 + all other boards in the future.]

pRU Registers and Bus System

The pRU bus system is connecting the various modules on the FPGA to a common master, the Microblaze Subsystem. Each of the modules is associated with a given BASE-ADDRESS specified in the pRU Control Interface Document. Note that several instances do exist for certain modules. E.g. there are one alpide_data instance for each ALPIDE chip connected to the pRU. To communicate with a specific instance one needs to add an offset of 0x1000 times the instance number to the module base address.

E.g. if you want to communicate with the

• 1st instance: <ALPIDE_DATA_BASEADDR>

• 2nd instance: <ALPIDE_DATA_BASEADDR> + (0x1000 * (2-1))

• 16th instance: <ALPIDE_DATA_BASEADDR> + (0x1000 * (16-1))

Module Registers

• global_regs
• trigger_manager
• offload
• alpide_control
• alpide_data

PTB-specific Module Registers

• power_control
• ptb_regs

Transition Card (TC)

• TC-v1.0 Schematic

ALPIDE Chip

• ALPIDE Manual v0.3

ALPIDE Bonding and Mounting

• 9-chip String Simulation - and proposed 9-chip string redesign - 2019 Feb

Chip Cable

• 2020 January 8
• 2019 May 16 (ULTM)

9 Chip String

• 2019 November 5
• Some of the aluminium traces on the flex cable broke by the tail of the cable (near the ZIF stiffener). Current design and possible modifications shows the current design and two possible modifications. It has been decided that new designs will use the design 1 modification and longer ZIF-stiffener (30 mm long).

Production Test Box (PTB)

• PTB-v1.0 Schematic
• PTB-v1.0 FPGA Connections
• PTB-v1.0 Yamaichi Connections

FPGA Mezzanine Card (FMC)

• FMC-v1.0 Schematic

mTower

• mTower Schematic

Cooling Laboratory Setup

1x LAUDA Ultracool UC 4 is used for water cooling in the laboratory now (data sheet and manual).

1x Digital flow switch with temperature sensor for the cold plate (flow rate 13,6 l/min) SMC PF3W520S-04-2T-R-X128

1x Digital flow switch with temperature sensor for the tracking layers (flow rate 3,2 l/min) SMC PF3W504S-03-2T-R-X128

2x Digital flow monitor (SMC PFG310-SV)

4x Meas Heavy Industrial Pressure Transmitter (M5131-70010X-004BC)

3x Axial fans 4-wire 12V

1x I/O Module Moxa ioLogik E1212 (8x digital inputs, 8x digital inputs/outputs)

1x I/O Module Moxa ioLogik E1240 (8x analog inputs)

• Schematic of the pCT lab setup